Once the drying gear is hauled out, most homes are left with open walls, bare subfloor and missing trim. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Royal Oak homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. You get a written, line-itemed scope before anyone picks up a hammer.
A rebuild after water damage is finish carpentry with an insurance file attached. The independent pros in our network do that kind of work every week in Royal Oak.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask to see the insurance certificate before work starts, and any solid contractor will hand it over.
You get a written estimate itemized down to square feet of board, linear feet of base and shoe, and labor hours. Many write it in the line-item style adjusters already use, which cuts the back and forth on the claim.
A rebuild is rarely a 2 a.m. emergency, but waiting weeks for a bid stalls the whole claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Royal Oak.
Rebuild crews carry texture hoppers, knockdown knives, trim saws and coping saws, not air movers. That kit, plus a steady hand, is what keeps a repaired wall from looking patched.
Each job follows the scope of loss: a written list of every material that came out during mitigation and has to go back in.
New drywall goes in above the flood cut, followed by tape, mud in three coats and a final sand. The hard part is texture: orange peel, knockdown and skip trowel all have to blend into the wall that stayed.
MDF base that drank up water stays swollen, so it gets pulled and replaced with the same profile. After a kitchen leak, toe-kicks and sometimes the whole sink base cabinet need replacing too.
Laminate and LVP tend to get replaced since water sits below the click joints and the core swells. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Good contractors repaint the affected walls corner to corner, so there is no halo around the repair.
Furniture, boxes and electronics can be photographed, inventoried, packed out and stored while the rebuild runs. That inventory also backs up the contents side of your insurance claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. Adjusters move faster when the paperwork answers their questions before they ask them.
Mitigation is the emergency half: stop the water, extract it, tear out what cannot be dried and run equipment until the readings hit dry standard. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Take a dishwasher supply line that dripped under the cabinets for days before anyone noticed. The dry-out crew pulls the toe-kicks, drills or opens the cabinet bases and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.
The process has four steps, and the first is a short phone call.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors send it straight to your adjuster and write a supplement if hidden damage turns up.
At the end you walk every room with the contractor and write down anything that does not look right. Sign off only after the punch list is cleared, and ask for any workmanship warranty in writing.
Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Upstairs toilet overflowed and a big chunk of the kitchen ceiling had to be cut out a week before the holidays. The contractor from the referral line matched our knockdown texture and repainted the full ceiling. You cannot tell where the hole was.
I figured the hallway oak was headed for the dumpster. The contractor took readings, confirmed it was solid hardwood that had dried out, and sanded and refinished it instead of tearing it out. It looks better than it did before the leak.
My rental had three rooms stripped to the studs and a tenant asking every day when it would be done. The local contractor I was connected with wrote a scope the adjuster barely changed, and the trim and paint matched the untouched rooms.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration puts the house back: drywall, texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Ask your contractor for a written schedule with the order of trades.
In most cases yes. Insurers may suggest a preferred vendor, but the homeowner usually gets to choose who works on the house. Read your policy and confirm with your adjuster before signing anything.
Many contractors in our network work directly with adjusters and write estimates in the format insurers expect.
Often, if they are solid hardwood and were dried quickly. Mild cupping can settle once the moisture content comes back to normal. The contractor checks readings over several days before deciding to sand and refinish.
Boards that have crowned, split or lifted, and most engineered planks, usually have to be replaced.
They should, if the contractor matches the texture on a test piece and repaints full walls instead of spot painting. Paint is matched from a chip of the existing wall, not from a guess at the color name.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The independent pros in our network are local, which means they know the houses around Royal Oak and how the permit desk works.
Older houses close to downtown Royal Oak often have plaster and real wood trim, which take more work to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.
Tell us what came out and we will connect you with a local contractor.
Call +1-877-637-9008