Licensed and Insured Independent Pros
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The water is gone and the fans have been picked up, but the kitchen still has a two-foot flood cut and no baseboards. Putting it back is restoration, and it is a different job from the cleanup.
Our referral line links Converse homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. You get a written, line-itemed scope before anyone picks up a hammer.

Restoration is drywall, trim and flooring work done on a house that just got soaked. The contractors we refer around Converse handle both the carpentry and the paperwork.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask for the certificate of insurance at the first visit; a good contractor has it ready.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many write it in the line-item style adjusters already use, which cuts the back and forth on the claim.
A rebuild is rarely a 2 a.m. emergency, but waiting weeks for a bid stalls the whole claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Converse.
Rebuild crews carry texture hoppers, knockdown knives, trim saws and coping saws, not air movers. That kit, plus a steady hand, is what keeps a repaired wall from looking patched.
The work follows the scope of loss, which lists each material removed during the dry-out that now has to be replaced.

Flood cuts get closed with new board, then tape, three coats of mud and sanding. The real skill is the texture, getting orange peel or knockdown to disappear into the original wall.
Wet MDF baseboard swells and never shrinks back, so it is replaced with a matching profile. After a kitchen leak, toe-kicks and sometimes the whole sink base cabinet need replacing too.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
A chip is cut from an undamaged wall and taken to the paint counter for a computer match. Good contractors repaint the affected walls corner to corner, so there is no halo around the repair.
Furniture, boxes and electronics can be photographed, inventoried, packed out and stored while the rebuild runs. The itemized list doubles as proof for the contents portion of the claim.
Before and after photos, the scope, the mitigation drying records and the final invoice go into one file. Adjusters move faster when the paperwork answers their questions before they ask them.
Mitigation is the emergency half: stop the water, extract it, tear out what cannot be dried and run equipment until the readings hit dry standard. What comes after is restoration, and the work looks a lot more like a remodel than an emergency call.
Picture a dishwasher supply line that seeped under the cabinets for days before anyone saw it. Mitigation pulls the toe-kicks, opens the cabinet bases for airflow and dries the subfloor. Restoration means sourcing a toe-kick that matches, swapping a swollen sink base and blending new flooring into the old at the doorway.
Or take an upstairs toilet overflow that came through the kitchen ceiling. After the wet ceiling drywall is cut out and the joists dry, someone still has to hang board overhead, match the texture and paint the full ceiling plane.
A crew that is fast and fearless with a reciprocating saw is not always the crew you want taping your living room.
Plenty of companies only do the dry-out. Ask any contractor directly whether the rebuild is included, and make sure the answer is in the written scope.

The process has four steps, and the first is a short phone call.
Tell the dispatcher what was removed during mitigation and whether you have an open claim. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
The contractor walks each room with a moisture meter to confirm the structure is truly dry before quoting.
You get a written scope with every line item: drywall, trim, flooring, paint, cabinet work and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
When the last coat of paint is dry, you walk the house with the contractor and build a punch list. Sign off only after the punch list is cleared, and ask for any workmanship warranty in writing.

Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. I called the referral line and got connected to a local contractor who found toe-kicks that matched and dealt with the adjuster's questions directly.
Upstairs toilet overflowed and a big chunk of the kitchen ceiling had to be cut out a week before the holidays. The contractor I was connected with hung new board, matched the knockdown and painted the whole ceiling. I honestly cannot find the patch.
I was sure the oak floor in our hallway was a total loss. The contractor took readings, confirmed it was solid hardwood that had dried out, and sanded and refinished it instead of tearing it out. Honestly the floor looks better now than before the leak.
My rental had three rooms stripped to the studs and a tenant asking every day when it would be done. The local contractor I was connected with wrote a scope the adjuster barely changed, and the trim and paint matched the untouched rooms.
One call connects you with an independent local contractor who handles the rebuild after water damage.
Mitigation stops the damage from spreading: extraction, tear-out of wet materials, antimicrobial treatment and drying to dry standard. Restoration puts the house back: drywall, texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. Most of the waiting is on material orders and adjuster approval, not labor.
Ask your contractor for a written schedule with the order of trades.
Generally you can. Your carrier may recommend a preferred vendor, but most policies let you hire the contractor you pick. Read your policy and confirm with your adjuster before signing anything.
A lot of the independent contractors we refer deal with adjusters every week and write estimates the way carriers like them.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. The contractor checks readings over several days before deciding to sand and refinish.
Boards that have crowned, split or lifted, and most engineered planks, usually have to be replaced.
They should, if the contractor matches the texture on a test piece and repaints full walls instead of spot painting. The paint is matched from a chip cut out of the original wall, not from an old can label.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The independent pros in our network are local, which means they know the houses around Converse and how the permit desk works.
Older homes near downtown Converse tend to have plaster walls and solid wood trim that take extra care to match. Newer neighborhoods have MDF trim and LVP, which are easy to buy but swell fast once wet.

Describe the open walls and we will route your call to a local pro.
Call +1-877-637-9008