Licensed and Insured Independent Pros
Extraction contractors we refer are independent local businesses that carry their own license and insurance. Ask to see proof of insurance on arrival, and a reputable crew will have it handy.
If water beads up when you press on the carpet, the pad underneath is soaked and evaporation alone will be painfully slow. Real extraction gear pulls water out of carpet, pad and floor seams far faster than any fan can dry it.
Our referral line connects Omro callers with independent, licensed and insured contractors who run truck-mounted and portable extractors. You get a written quote before the extraction wand ever hits the carpet.

Extraction is a pure equipment job: the power of the machine and the right tool head decide how much water comes out.
Extraction contractors we refer are independent local businesses that carry their own license and insurance. Ask to see proof of insurance on arrival, and a reputable crew will have it handy.
The estimate spells out square footage extracted, pad removal if needed and any equipment left behind. Plenty of them work straight with your adjuster once a claim is open.
Carpet pad sitting in water begins to smell fast, which makes a quick response the whole ballgame. Our dispatcher confirms a real arrival window with a crew near Omro while you are on the phone.
Crews bring truck-mounted units with far more vacuum lift than any rental, plus portable extractors for high-rise and tight units. Stand-on and weighted tools press body weight into the carpet so the pad gives up its water, not only the top fibers.
Each gallon removed by the extractor is a gallon that never has to be evaporated and captured by a dehumidifier. Extraction removes water in liquid form, which is many times faster than turning it into vapor with air movers. Leave it out and the drying phase stretches for days.
A shop vac falls short because it only pulls from the surface and has a fraction of the lift of a truck mount. It also never reaches the pad, and that is where most of the water is hiding. Folks run one all evening and still end up with carpet that squishes.
Take a refrigerator ice-maker line that leaked into wall-to-wall carpet overnight. That is clean water, so the crew may float the carpet: lift it off the tack strip, pull the soaked pad, extract the carpet in place and set drying underneath it.
Laminate is a tougher case: when water runs under the planks in a rental unit, it sits in the underlayment where you cannot see it. Meters and specialty mats show how far it spread, and any planks with swollen edges usually have to come up.
Rule of thumb from the field: carpet in clean water can often be saved, but the pad underneath is usually thrown out and replaced. Pad is cheap; carpet is not.
Time matters too: clean water left sitting for days in a warm house picks up bacteria, which shrinks the list of what can be saved. That is one more reason to get the extractor in early.

Each material holds water differently, so each one gets a different tool and technique.

The crew makes slow overlapping passes with a weighted tool until the wand stops pulling water. Wet pad is usually cut out and bagged, then the carpet is relaid once dry.
For a clean-water leak, the crew can pull the carpet off the tack strip, slide air underneath and dry it in place. This saves the carpet and keeps it out of the dumpster.
Flat panels sealed to the floor pull water up through the seams and out of the boards under vacuum. When caught early, it often stops solid hardwood from cupping.
With click-together planks, water runs underneath and pools on the subfloor out of sight. Crews read moisture across the floor, pull planks where it is wet and extract the subfloor directly.
Sofas, chairs and rugs get extracted with smaller hand tools sized for fabric. Wool and handmade rugs often go out to a rug plant for proper washing and drying.
Once the water is out, the tech maps moisture across the floor and along the base of the walls. Those readings tell the crew where the drying equipment should go.
Let the dispatcher know the flooring type, the size of the wet area and the source of the leak. We route you to the nearest independent extraction crew and give you an arrival window.
Expect extractors, tool heads, meters and hoses, plus a portable unit if you live upstairs.
First the tech identifies the water source and category, measures the wet area and decides what stays, then puts the quote in writing.
After extraction, the tech takes final readings, sets drying equipment if needed and walks you through what was done.

The fridge ice-maker line let go overnight and the living room carpet was wet from the kitchen to the far wall. The contractor I was connected with pulled the pad, extracted the carpet with a stand-on tool and saved the carpet itself. There was no musty smell later, which was my biggest worry.
Water from the hall closet in my apartment ran under the laminate before I noticed. The crew my landlord and I were connected with found it with a meter, pulled the wet planks and extracted the subfloor.
I spent three hours with my shop vac and the carpet still squished. The contractor showed up with a truck mount and got more out of that room in a few passes than I did all night.
The washer drain hose came loose and water ran under the hallway hardwood while we were at work. The crew from the referral service set vacuum mats across the wood and ran them for hours. The floor cupped a little and then flattened back out as it dried.
Usually, when the water was clean and the carpet was extracted within a day or so. The pad below is normally thrown out, since it traps water and smell.
If sewage or floodwater soaked it, the carpet generally has to go.
A shop vac only pulls from the surface and has a fraction of the lift of a professional truck mount. Most of the water sits in the pad and subfloor, which a wet vac cannot reach.
Pros use weighted tools that press water out of the pad while the extractor pulls it away.
Extraction itself often takes a few hours for a typical room or two. Drying afterward is a separate step that can take several days.
After checking the size of the wet area, the crew can tell you how long it should take.
Not if the pad is removed, the carpet is extracted thoroughly and it dries quickly. A smell usually means water stayed in the pad or subfloor for too long.
You can ask the crew if an antimicrobial treatment makes sense for your floor.
Extraction is the vacuum step that removes liquid water from carpet, pad and flooring. Drying is what follows, with dehumidifiers and air movers removing what is left behind.
The better the extraction, the shorter the drying phase.
The extraction contractors we refer are local, so the truck mount is not hours away.
Upstairs condos and apartments often need portable extractors because hoses cannot reach from the street. Houses and small storefronts usually get a truck mount parked right outside.

Call and we will connect you with a local extraction crew.
Call +1-877-637-9008The faster the pad and carpet are extracted, the more you save. Call now for a local crew.