After mitigation wraps up, the house usually looks worse than it did on the day the leak started. Rebuilding all of that is restoration, which is its own trade with its own crews.
Our referral line links Sells homeowners with independent, licensed and insured contractors who handle the rebuild from drywall to paint. Every job starts with an itemized written scope you can hand straight to your adjuster.
A rebuild after water damage is finish carpentry with an insurance file attached. The contractors we refer around Sells handle both the carpentry and the paperwork.
The rebuild contractor you reach through our line is an independent local outfit with its own license and insurance. Ask to see the insurance certificate before work starts, and any solid contractor will hand it over.
The estimate comes in writing, broken out by square feet of drywall, linear feet of baseboard and hours of labor. Many contractors use the same line-item format adjusters work in, so the claim review moves faster.
Restoration is not usually a midnight job, yet a slow bid can hold up your entire claim. The dispatcher sets a real walkthrough window on the call with a contractor based close to Sells.
Rebuild crews carry texture hoppers, knockdown knives, trim saws and coping saws, not air movers. That gear and some patience are what make a patched wall look like it was never cut.
The work follows the scope of loss, which lists each material removed during the dry-out that now has to be replaced.
New drywall goes in above the flood cut, followed by tape, mud in three coats and a final sand. The hard part is texture: orange peel, knockdown and skip trowel all have to blend into the wall that stayed.
Wet MDF baseboard swells and never shrinks back, so it is replaced with a matching profile. After a kitchen leak, toe-kicks and sometimes the whole sink base cabinet need replacing too.
LVP and laminate are usually replaced because water stays trapped under the locking joints. Solid hardwood caught early can often be sanded and refinished; engineered planks rarely come back.
The crew cuts a small chip from a dry wall and has the paint store scan it for a match. Good contractors repaint the affected walls corner to corner, so there is no halo around the repair.
Contents can be boxed, listed and stored off-site so the crew has open rooms to work in. That inventory also backs up the contents side of your insurance claim.
The contractor keeps the scope, progress photos, drying records and invoices together in a single file. A complete file usually means fewer re-inspections and fewer arguments over supplements.
Mitigation is the emergency half: stop the water, extract it, tear out what cannot be dried and run equipment until the readings hit dry standard. Restoration is everything after that, and it is much closer to remodeling than to cleanup.
Take a dishwasher supply line that dripped under the cabinets for days before anyone noticed. Mitigation pulls the toe-kicks, opens the cabinet bases for airflow and dries the subfloor. Restoration is the part where someone finds a matching toe-kick, replaces the swollen sink base and ties new flooring into the old at the doorway.
Or think about an upstairs toilet that overflowed and rained down through the kitchen ceiling. Once the soaked ceiling board is down and the joists read dry, someone still has to hang new board overhead, match the texture and repaint the whole ceiling.
The crews that are great at fast tear-out are not always the ones you want doing finish work in your living room.
Some companies do both halves and many do just one. Ask outright whether the rebuild is part of the job, and get that answer in writing.
Four steps, and the first one takes about five minutes on the phone.
Let the dispatcher know what came out during the dry-out and whether a claim is already open. We route you to an independent local rebuild contractor and lock in a walkthrough time on the same call.
Your contractor checks every affected room with a meter first, because closing up a wet wall is the most expensive mistake in this trade.
The written quote lists each line: board by the square foot, base by the linear foot, flooring, paint and contents handling. Many contractors submit it to the adjuster and add a supplement if more damage shows up behind a wall.
When the last coat of paint is dry, you walk the house with the contractor and build a punch list. Sign off only after the punch list is cleared, and ask for any workmanship warranty in writing.
Our dishwasher line leaked under the cabinets for days. When the drying crew left, the sink base was swollen and the toe-kicks were sitting in the garage. The referral line put me in touch with a local contractor who matched the cabinet toe-kicks and talked to our adjuster so I was not stuck in the middle.
Our kids clogged the upstairs toilet, it overflowed, and the kitchen ceiling ended up with a hole the size of a door. The contractor I was connected with hung new board, matched the knockdown and painted the whole ceiling. I honestly cannot find the patch.
I was sure the oak floor in our hallway was a total loss. The contractor I reached through the referral service checked the boards, said they were solid oak and dry, and refinished them rather than replacing them. It looks better than it did before the leak.
I own a duplex and the tenant was living out of two rooms while the rest sat gutted. The contractor gave me a line-item scope the insurance company accepted almost as written, and the paint matched on the first try.
Call now and a dispatcher will connect you with an independent rebuild contractor near Sells.
Mitigation is the emergency work that keeps damage from growing: water removal, tear-out, antimicrobial and drying. Restoration is the rebuild that follows: new drywall, matched texture, trim, flooring, cabinets and paint.
Adjusters often see them as two estimates on one claim, sometimes from two different contractors.
That comes down to scope: one room of board and paint goes quickly, but a kitchen with cabinets and flooring takes much longer. The delays usually come from backordered materials and claim approvals rather than the actual work.
Ask your contractor for a written schedule with the order of trades.
Generally you can. Your carrier may recommend a preferred vendor, but most policies let you hire the contractor you pick. Read your policy and confirm with your adjuster before signing anything.
Many contractors in our network work directly with adjusters and write estimates in the format insurers expect.
Solid hardwood that was dried fast often can be. Light cupping may flatten as the moisture content returns to normal. A good contractor takes readings over a few days before deciding whether to sand and refinish.
Boards that have crowned, split or lifted, and most engineered planks, usually have to be replaced.
A careful contractor tests the texture on scrap and paints whole walls to the corners so the repair blends in. The paint is matched from a chip cut out of the original wall, not from an old can label.
Look at the texture sample before it goes up, and check the finished wall in daylight before you sign off.
The contractors we refer live and work in the area, so they know the local housing stock and the local permit office.
Older houses close to downtown Sells often have plaster and real wood trim, which take more work to match. Newer subdivisions mean builder-grade drywall, MDF base and LVP that are easier to source but quick to swell.
Describe the open walls and we will route your call to a local pro.
Call +1-877-637-9008